![]() We recommend the larger memory modules be installed in the lowest available banks. If a memory module is not installed properly, it could cause damage to the computer. ![]() When installed, ensure that both sides of the memory module are snapped into place. As the memory module is moved to a vertical position, it should snap into place. The memory is placed into the slot at a 75-degree angle and while still in the memory slot, moved to a vertical (90-degree) angle. The installation of most SIMM memory is the same. Therefore, two memory modules of equal value must be installed in pairs, unless instructed otherwise by the computer or motherboard manufacturer. Computers that use 72-pin SIMMs have two sockets as one bank. SIMM memory installation stepsģ0 and 72-pin SIMM (single inline memory module) memory modules must occupy a bank. The memory should also lay horizontally with the computer. Once it's in the slot, press down on the memory to snap it into place. The memory must be inserted at an angle (approximately 75 degrees). ![]() Today, most laptops follow the same memory installation.īecause laptops are thin compared to a desktop computer, the memory banks are horizontal with the laptop. Once the slots are located, the next step is to install the computer memory. If you cannot locate the slots after looking at each of the above recommendations, we recommend you contact the computer manufacturer for additional help and information. On a compartment on the bottom of the laptop.If you are unfamiliar with where these slots are located, below is a listing of possible locations: Notebook (laptop) memory installation stepsīefore the memory can be installed into a notebook, the memory slots must be located. As the memory module is being pushed, the two tabs should snap and hold the memory module into place. When the C-RIMM module is removed, and the two tabs are in the outward position, push the RIMM memory module to a vertical or 90-degree angle. This module is a small circuit board and has only a few or no chips on it. ![]() When installing a new RIMM, remove the C-RIMM. This module allows the computer to have a continuous flow of data. What makes RIMM memory modules different from DIMM memory modules is the C-RIMM (continuity RIMM) memory module.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |